The most useful piece of a broken knob may be the hole underneath it. The outside tells us how the knob should feel in your hand. The hole tells us whether it will actually turn the shaft. When an original spare is hard to find, details like these help decide whether a printed replacement is practical.
Keep the broken pieces
Photograph the part from the front, side and underside, then photograph the place where it fits. Include a ruler for scale and write down the measurements you can take directly. For a dial, the shaft diameter, the shape of its flat and the available depth matter more than an exact match to its decorative ridges. Keep any surviving fragments, even if they no longer hold together.

Work out why the original failed
A clip that snapped the first time it was fitted is a different problem from one that slowly distorted beside a heat source. Tell us how the part is used, how often it moves and what force or heat it sees. If a failure could injure someone, a successful fit alone is insufficient. An approved replacement or an engineering assessment may be the right route.
Test the fit before recreating every detail
For the knob example, the first print could be just the hub and shaft opening. Does it slide on far enough? Can it turn without slipping? Can it come off again without damaging the shaft? Once the interface works, the rest of the shape can be added and checked in place.
If you have a broken part in Aberdeen or elsewhere in the UK, send Robin a few photos and the key dimensions. A useful first message is simply: “This is where it fits, this is how it broke, and this is what it needs to do.”
A documented example: replacing a radio knob with a printed spare.





